Tuning Condenser rubber mounts for model 38-10

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Tuning Condenser rubber mounts for model 38-10

BOB C.
Junior Member

Posts: 11
Threads: 4
Joined: Mar 2007

03-19-2007, 10:28 PM

Thanks guys. I don't know if 38-12 and the 38-10 have the same mounting setup. I really don't see how I could use a rubber grommet for this setup as it is a rectangular tab going into a rectangular hole. The factory rubber slips over prongs on either side of the chassis. I will check out the grommet selection and see whats in there.
Also thanks for the tip on the shields. I will give him a call. Bob

Robert Chesarek
Renfrew, PA

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Tuning Condenser rubber mounts for model 38-10 - by BOB C. - 03-18-2007, 04:58 PM

Condenser mounts fix - by ecmorris - 03-18-2007, 07:29 PM

Tuning condenser rubber mounts for model 38-10 - by William - 03-18-2007, 08:30 PM

[No subject] - by BOB C. - 03-19-2007, 10:28 PM

[No subject] - by planigan - 03-21-2007, 01:22 AM

[No subject] - by Bill Hutchinson - 03-21-2007, 02:17 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM
6TPZ and 5TPO Radio Help
I suspect it's been repaired before. And I suspect whoever repaired it, wanted to re-use old transistors' pin stubs in o...morzh — 09:24 PM

Who's Online

There are currently 9676 online users. [Complete List]
» 3 Member(s) | 9673 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me