Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Another Volume Control Question
#4

You are doing fine. The two on the back of the control are the on of switch. The three on the control are for volume. Disconnect either extreme end, and measure resistance end to end, should be 100,000 to maybe 500,000 ohms, but definitely not open circuit.The "arm" or center tab should vary on the ohm meter from near zero to the limit of the control as you advance or decrease the movement. Do al this stuff definitely with power off.

If you don't have a dependable meter, there are a lot of modern inexpensive digital meters (less than $25) available everywhere.


Messages In This Thread
Another Volume Control Question - by winkydink - 11-20-2012, 11:23 AM
RE: Another Volume Control Question - by codefox1 - 11-20-2012, 12:20 PM
RE: Another Volume Control Question - by codefox1 - 11-21-2012, 12:08 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 60
This is my thread on 60 from 2016. I had to rewind the osc coil, and I actually counted the turns and then rewound i...morzh — 03:34 PM
Philco model 60
Yes, Mark belongs to the same Michigan Antique Radio Club that I do. I suspect that the oscillator coil is in need of a ...Radios1340 — 03:10 PM
A Marconi model 86
Yeah. I am dreading the thought of what to do with all my consoles when I will no longer be able to move them around. I...morzh — 02:51 PM
1947 Silvertone 7086 Wire Recorder/Phono/Radio on YouTube
Cool gadget, Buzz. I took me a couple of second to undestand that that oscillating thing makes the wire to spool correc...morzh — 02:50 PM
A Marconi model 86
My back hurts already, you could build a house with all the wood. PaulPaul Philco322 — 02:49 PM
1947 Silvertone 7086 Wire Recorder/Phono/Radio on YouTube
Part 4 of this series now uploaded link below to anyone interested Buzz — 02:39 PM
Philco model 60
Welcome to the Phorum, Radios1340!  The oscillator coil on the 60 is a common culprit.  I just bought a 60B (June 1934) ...GarySP — 02:33 PM
Philco model 60
Yes, standard alignment procedure. I can get the minuscule tone to vary when adjusting the trimmers. But you almost have...Radios1340 — 01:40 PM
A Marconi model 86
An imposing-looking radio, for sure.morzh — 12:43 PM
Philco model 60
Model 60 struck again :lol: Welcome to the Phorum! Above is the article on Model 60. Could be of some use. Now...morzh — 12:38 PM

[-]
Who's Online
There are currently 7265 online users. [Complete List]
» 1 Member(s) | 7264 Guest(s)
Avatar

>