Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Model 66 Repair
#12

I have attached a link to the "alternate" forum, same questions. Certainly no problem with this. Might give you a little more background on Mike's problems. Good luck and maybe you can get more help here. I will state Mike again that if the coil has a resistor (10K) inside it your are working on the Antenna coil. NOT the oscillator.
Jerry

http://antiqueradios.com/forums/viewtopi...6&t=209482

A friend in need is a pest!  Bill Slee ca 1970.


Messages In This Thread
Philco Model 66 Repair - by radiola - 11-21-2012, 12:43 AM
RE: Philco Model 66 Repair - by 7estatdef - 11-21-2012, 06:07 PM
RE: Philco Model 66 Repair - by jph14 - 11-21-2012, 07:53 PM
RE: Philco Model 66 Repair - by radiola - 11-21-2012, 08:00 PM
RE: Philco Model 66 Repair - by 7estatdef - 11-21-2012, 10:08 PM
RE: Philco Model 66 Repair - by TA Forbes - 11-21-2012, 10:25 PM
RE: Philco Model 66 Repair - by radiola - 11-21-2012, 11:10 PM
RE: Philco Model 66 Repair - by 7estatdef - 11-22-2012, 12:58 AM
RE: Philco Model 66 Repair - by radiola - 11-23-2012, 10:12 PM
RE: Philco Model 66 Repair - by 7estatdef - 11-25-2012, 05:39 PM
RE: Philco Model 66 Repair - by radiola - 11-25-2012, 06:20 PM
RE: Philco Model 66 Repair - by jerryhawthorne - 11-25-2012, 09:30 PM
RE: Philco Model 66 Repair - by radiola - 11-25-2012, 10:48 PM
RE: Philco Model 66 Repair - by 7estatdef - 11-25-2012, 11:21 PM
RE: Philco Model 66 Repair - by radiola - 11-26-2012, 10:01 PM
RE: Philco Model 66 Repair - by 7estatdef - 11-27-2012, 12:16 AM
RE: Philco Model 66 Repair - by radiola - 11-27-2012, 01:12 AM
RE: Philco Model 66 Repair - by 7estatdef - 11-27-2012, 11:20 PM
RE: Philco Model 66 Repair - by TA Forbes - 11-27-2012, 11:47 PM
RE: Philco Model 66 Repair - by radiola - 11-28-2012, 12:34 AM
RE: Philco Model 66 Repair - by 7estatdef - 11-28-2012, 11:32 PM
RE: Philco Model 66 Repair - by radiola - 11-29-2012, 02:21 AM
RE: Philco Model 66 Repair - by 7estatdef - 11-29-2012, 10:30 PM
RE: Philco Model 66 Repair - by radiola - 11-30-2012, 02:32 AM
RE: Philco Model 66 Repair - by 7estatdef - 11-30-2012, 06:54 PM
RE: Philco Model 66 Repair - by radiola - 11-30-2012, 11:30 PM
RE: Philco Model 66 Repair - by 7estatdef - 12-01-2012, 06:51 PM
RE: Philco Model 66 Repair - by radiola - 12-02-2012, 10:41 PM
RE: Philco Model 66 Repair - by 7estatdef - 12-02-2012, 10:53 PM
RE: Philco Model 66 Repair - by 7estatdef - 12-04-2012, 11:00 PM
RE: Philco Model 66 Repair - by radiola - 12-05-2012, 12:52 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM
A Marconi model 86
Thanks Arran; I don't even know what a double conversion is, but i do have a good friend In Nova Scotia that would k...Dan Walker — 07:01 PM
A Marconi model 86
Dan; I've seen some Marconi sets like that before, one was a console though I'm not sure if it was a model 86. It's a...Arran — 05:09 PM
An attempt to remove the Field Coil from a G speaker
Milkjug plastic? Whatever is chosen for the spider, the material must be compatible with popular adhesives... Th...Chas — 05:05 PM

[-]
Who's Online
There are currently 3273 online users. [Complete List]
» 4 Member(s) | 3269 Guest(s)
AvatarAvatarAvatarAvatar

>