Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need help with Philco 620
#5

Thank you. thank you, thank you!!!!.

The field coil was shorted to the chassis where the hushatone was previously installed. That problem fixed, the coil no longer gets hot.
I had a bad solder joint to one of the electrolytic caps too. Problem fixed, the radio works now...

The tone control is bad though. I am getting sound now, and can tune stations, but only when the tone control is in the open position. I was touching the lead earlier, but one hand in pocket, standing on carpet, using a plastic tool. I am sorry.. it was stupid.

Thank you guys for putting me on the right track. I was giving up. FYI - your answers matched the 1943 edition of Radio Troubleshooters Handbook. You guys are good! ...

Now the question is, what is the value of the tone control? the Philco part number is 30-4316... Can I just solder a cap across the leads, or do I need to find a new tone control?

The artist formerly known as Puhpow! 8)


Messages In This Thread
Need help with Philco 620 - by Jamie - 08-09-2013, 03:16 PM
RE: Need help with Philco 620 - by marty - 08-09-2013, 05:44 PM
RE: Need help with Philco 620 - by Phlogiston - 08-09-2013, 06:28 PM
RE: Need help with Philco 620 - by morzh - 08-09-2013, 06:50 PM
RE: Need help with Philco 620 - by Jamie - 08-09-2013, 07:28 PM
RE: Need help with Philco 620 - by Phlogiston - 08-09-2013, 08:13 PM
RE: Need help with Philco 620 - by Jamie - 08-09-2013, 08:32 PM
RE: Need help with Philco 620 - by Phlogiston - 08-09-2013, 08:48 PM
RE: Need help with Philco 620 - by Jamie - 08-09-2013, 09:12 PM
RE: Need help with Philco 620 - by Jamie - 08-14-2013, 09:44 AM
RE: Need help with Philco 620 - by Phlogiston - 08-14-2013, 10:02 AM
RE: Need help with Philco 620 - by Jamie - 08-14-2013, 12:22 PM
RE: Need help with Philco 620 - by Arran - 08-14-2013, 07:57 PM
RE: Need help with Philco 620 - by Jamie - 08-15-2013, 08:47 AM
RE: Need help with Philco 620 - by marty - 08-15-2013, 02:37 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM

[-]
Who's Online
There are currently 9030 online users. [Complete List]
» 1 Member(s) | 9029 Guest(s)
Avatar

>