Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

I bought a Philco 37-650 today..
#19

I've never had much luck on permanently repairing veneer cracked across the grain over a curve like that, especially that long of a crack. Part of the reason it cracked is that the veneer is already under tension where it wraps around that curve and whatever was under it obviously absorbed some moisture, swelled up, and pushed the veneer past it's limits. Wood generally expands and contracts across the grain, not along the grain, so it could not have cracked because of shrinkage. What you can reasonably do about it is another story, it definatley is not the sort of thing for beginners to tackle, it usually involves taking the cabinet apart to a certain extent, removing the old veneer, and then replacing it. It may be easier to find an empty cabinet then to repair that veneer, the good news is that it was a fairly common style.
Regards
Arran


Messages In This Thread
I bought a Philco 37-650 today.. - by Jamie - 08-18-2013, 03:54 PM
RE: I bought a Philco 37-650 today.. - by KCMike - 08-18-2013, 10:55 PM
RE: I bought a Philco 37-650 today.. - by Jamie - 08-19-2013, 07:15 AM
RE: I bought a Philco 37-650 today.. - by Jamie - 08-19-2013, 01:36 PM
RE: I bought a Philco 37-650 today.. - by AI2V - 08-20-2013, 03:59 PM
RE: I bought a Philco 37-650 today.. - by AI2V - 08-21-2013, 11:04 AM
RE: I bought a Philco 37-650 today.. - by Jamie - 08-21-2013, 03:43 PM
RE: I bought a Philco 37-650 today.. - by Arran - 08-22-2013, 10:44 PM
RE: I bought a Philco 37-650 today.. - by Jamie - 10-02-2013, 08:50 AM
RE: I bought a Philco 37-650 today.. - by Jamie - 10-06-2013, 04:15 PM
RE: I bought a Philco 37-650 today.. - by PT57 - 10-20-2013, 03:03 PM
RE: I bought a Philco 37-650 today.. - by Jamie - 10-20-2013, 03:54 PM
RE: I bought a Philco 37-650 today.. - by PT57 - 10-20-2013, 03:56 PM
RE: I bought a Philco 37-650 today.. - by Jamie - 10-20-2013, 04:58 PM
RE: I bought a Philco 37-650 today.. - by Jamie - 11-01-2013, 06:46 PM
RE: I bought a Philco 37-650 today.. - by PT57 - 11-01-2013, 09:23 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM
6TPZ and 5TPO Radio Help
I suspect it's been repaired before. And I suspect whoever repaired it, wanted to re-use old transistors' pin stubs in o...morzh — 09:24 PM

[-]
Who's Online
There are currently 9751 online users. [Complete List]
» 1 Member(s) | 9750 Guest(s)
Avatar

>