Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco (UK) Model 282 Empire Five
#27

There was no tax based on tube count in Britain as far as I can find out. However there was a stigma against higher tube count sets because there was a manufacturer's cartel called the British Valve Association that sold valves/tubes to manufacturer's on a loss leading basis that then gouged customers on replacements, that is according to an article I read in a Radio Craft magazine from around 1946. This was in part the motivation behind sets like the Philco 444 "People's Radio". The author made no mention of a tax on tube counts only the purchase tax which was a big incentive to buy a cheaper radio, and it was cheaper to make and sell a radio with fewer tubes. This was mostly in the pre war era but I don't know if it applied to imported tubes, which is mostly what Philco used. It must have went away by the 1950s however as it's not uncommon to run into a PYE, a Murphy, or a Bush set with more then five tubes, but by then things were more standardized and they were using the same tubes as they did on the continent.
Regards
Arran


Messages In This Thread
RE: Philco (UK) Model 282 Empire Five - by Arran - 11-02-2012, 08:19 PM
RE: Philco (UK) Model 282 Empire Five - by exray - 11-03-2012, 06:27 AM
RE: Philco (UK) Model 282 Empire Five - by Arran - 11-06-2012, 02:08 AM
RE: Philco (UK) Model 282 Empire Five - by Arran - 11-08-2012, 12:46 AM
RE: Philco (UK) Model 282 Empire Five - by Jamie - 08-08-2013, 08:11 AM
RE: Philco (UK) Model 282 Empire Five - by GarySP - 08-08-2013, 10:53 AM
RE: Philco (UK) Model 282 Empire Five - by Arran - 09-18-2013, 10:26 PM
RE: Philco (UK) Model 282 Empire Five - by Arran - 11-19-2018, 05:23 AM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM

[-]
Who's Online
There are currently 5310 online users. [Complete List]
» 5 Member(s) | 5305 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>