1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Pulling hair over Apex 7A!
BrendaAnnD
Phorum Expert
*****
Posts: 1,106
Threads: 88
Joined: Jun 2011
City: Tacoma State, Province, Country: Washington
#5

10-27-2013, 10:03 PM
I'll have to check again. The tapped resistor is all perfect. I'll try to get all the voltages and post them later. Should I be taking them from the HT center tap, or the chassis? What few voltages are listed on the schematic are K-P or K-G.
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Pulling hair over Apex 7A! - by BrendaAnnD - 10-27-2013, 02:53 PM
RE: Pulling hair over Apex 7A! - by Mondial - 10-27-2013, 06:26 PM
RE: Pulling hair over Apex 7A! - by BrendaAnnD - 10-27-2013, 08:33 PM
RE: Pulling hair over Apex 7A! - by Mondial - 10-27-2013, 09:10 PM
RE: Pulling hair over Apex 7A! - by BrendaAnnD - 10-27-2013, 10:03 PM
RE: Pulling hair over Apex 7A! - by Mondial - 10-27-2013, 10:56 PM
RE: Pulling hair over Apex 7A! - by Radioroslyn - 10-27-2013, 11:38 PM
RE: Pulling hair over Apex 7A! - by BrendaAnnD - 10-28-2013, 08:45 AM
RE: Pulling hair over Apex 7A! - by Mondial - 10-28-2013, 09:12 AM
RE: Pulling hair over Apex 7A! - by BrendaAnnD - 10-28-2013, 04:40 PM
RE: Pulling hair over Apex 7A! - by Mondial - 10-28-2013, 04:48 PM
RE: Pulling hair over Apex 7A! - by morzh - 10-28-2013, 09:52 PM
RE: Pulling hair over Apex 7A! - by Arran - 10-29-2013, 02:46 AM
RE: Pulling hair over Apex 7A! - by BrendaAnnD - 10-29-2013, 09:17 AM
RE: Pulling hair over Apex 7A! - by Chuck Schwark - 10-29-2013, 09:23 AM
RE: Pulling hair over Apex 7A! - by Eliot Ness - 10-29-2013, 09:41 AM
RE: Pulling hair over Apex 7A! - by codefox1 - 10-30-2013, 07:41 AM
RE: Pulling hair over Apex 7A! - by Gene Pederson - 11-01-2013, 04:08 PM
RE: Pulling hair over Apex 7A! - by Arran - 11-01-2013, 10:27 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)