Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need a decent schematic Scott Laureate
#24

From what I've noticed over the years, the people who have started young and learned electronics sort of on their own or with personal mentors tend to be far better at the practical side of electronics than people who purely learned it in a school. I think it is the inherent interest in the subject that makes them really get to understand the stuff better than someone just doing it for a job. They also tend to be better circuit designers because they've seen all the historical circuits and variations that you just don't find in textbooks.

Brenda, your story sounds very similar to my own. I also can't remember a time when I was not doing something with electronics. I had a grandfather who ran a radio and TV "hospital" so I remember hanging around the TV shop and watching all the goings on very early on. Somehow the smell of charred phenolic always seemed like a natural smell to me!

In my case I went on to get a degree in electrical engineering but during my entire college experience I hardly ever ran into faculty who knew the practical side. They were great at the math and physics etc... but some of them hardly knew what a soldering iron was.

Herb S.
Ithaca NY


Messages In This Thread
RE: Need a decent schematic Scott Laureate - by hsusmann - 02-01-2014, 01:47 PM



Users browsing this thread: 8 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently no members online.

>