Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need a decent schematic Scott Laureate
#25

Yes it seems that the best engineers and designers started young with their interest in electronics. Having an early interest and enthusiasm for the subject certainly contributes to success in later professional careers.

My background is similar, starting around age 10 building radios and repairing broken ones, Later, worked on getting amateur radio and commercial radiotelephone licenses, which led to jobs in two-way radio communications while studying engineering in college.

It seems all the engineers that I knew from school that achieved the greatest success, were either hams or hobbyists before ever formally studying electronics. Unfortunately, the present generation of kids don't seem to have the interest, which is not encouraging for the future of technical professions in this country.

You can always tell when an engineer without a practical background designed a piece of equipment when you try to repair it. Servicing electronics before ever designing it gives an insight that is a definite asset.


Messages In This Thread
RE: Need a decent schematic Scott Laureate - by Mondial - 02-01-2014, 02:22 PM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently no members online.

>