Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Tale of a Z
#1

A few days ago, I got in a Zenith 4B231, nice little 6 volt farm set (seller thought it had a missing cord). The case looks pretty nice, and I may not even try to refinish it.
   

However, this is what it looked like from the back.
   

Note the forest green house paint, laid on with a fairly large brush.

   

This is after I have scraped and sanded part of the chassis. I have also removed the cans over the IF's, RF coil, and vibrator. I stripped those, sanded, primed and repainted them with stainless steel paint (closest thing I could find to the original look).

As you can see, underneath the green was some awful neon orange house paint (both are enamel and very difficult to remove..) This is after more scraping and sanding. I have now applied a generous coating of paint remover, and will see later this evening if it has softened it up enough to remove without a chisel. If I end up having to remove everything from the chassis in order to clean all that garbage off of there, I will. I'll do the same as I did with the cans, since I have no way of getting any hammertone brass paint.

Wish me luck!


Messages In This Thread
Tale of a Z - by BrendaAnnD - 02-06-2014, 12:55 AM
RE: Tale of a Z - by OldRestorer - 02-06-2014, 08:49 AM
RE: Tale of a Z - by TA Forbes - 02-06-2014, 10:07 AM
RE: Tale of a Z - by BrendaAnnD - 02-06-2014, 10:26 AM
RE: Tale of a Z - by morzh - 02-06-2014, 10:38 AM
RE: Tale of a Z - by TA Forbes - 02-06-2014, 10:40 AM
RE: Tale of a Z - by morzh - 02-06-2014, 10:53 AM
RE: Tale of a Z - by exray - 02-06-2014, 11:53 AM
RE: Tale of a Z - by BrendaAnnD - 02-06-2014, 04:03 PM
RE: Tale of a Z - by morzh - 02-06-2014, 04:35 PM
RE: Tale of a Z - by BrendaAnnD - 02-06-2014, 09:03 PM
RE: Tale of a Z - by morzh - 02-06-2014, 09:08 PM
RE: Tale of a Z - by Arran - 02-07-2014, 12:14 AM
RE: Tale of a Z - by BrendaAnnD - 02-07-2014, 02:57 AM
RE: Tale of a Z - by Conelrad - 02-07-2014, 07:51 AM
RE: Tale of a Z - by keithw - 02-07-2014, 10:56 AM
RE: Tale of a Z - by morzh - 02-07-2014, 10:58 AM
RE: Tale of a Z - by BrendaAnnD - 02-07-2014, 01:19 PM
RE: Tale of a Z - by BrendaAnnD - 02-07-2014, 01:25 PM
RE: Tale of a Z - by hsusmann - 02-07-2014, 11:53 PM
RE: Tale of a Z - by Arran - 02-08-2014, 05:15 AM
RE: Tale of a Z - by BrendaAnnD - 02-08-2014, 05:45 AM
RE: Tale of a Z - by hsusmann - 02-08-2014, 08:45 AM
RE: Tale of a Z - by BrendaAnnD - 02-08-2014, 10:17 AM
RE: Tale of a Z - by BrendaAnnD - 02-09-2014, 04:05 AM
RE: Tale of a Z - by hsusmann - 02-09-2014, 09:13 AM
RE: Tale of a Z - by BrendaAnnD - 02-09-2014, 09:33 AM
RE: Tale of a Z - by hsusmann - 02-09-2014, 09:40 AM
RE: Tale of a Z - by morzh - 02-09-2014, 12:34 PM
RE: Tale of a Z - by wireless - 02-09-2014, 01:21 PM
RE: Tale of a Z - by Tom Hamilton - 02-11-2014, 01:51 PM
RE: Tale of a Z - by TA Forbes - 02-18-2014, 12:51 PM
RE: Tale of a Z - by BrendaAnnD - 02-20-2014, 09:14 AM
RE: Tale of a Z - by Tom Hamilton - 02-20-2014, 10:21 AM
RE: Tale of a Z - by morzh - 02-20-2014, 11:05 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 40-120C Filament Wiring
Thank you for your replies. That is the correct schematic and pin out diagram for the rectifier. The resistance acro...bluecap — 11:01 AM
Philco 46-480 Electronic Restoration
Late last night a guy reached out in response to my posting on the Antique Radio Forum and suggested I contact Trust Aut...jrblasde — 11:01 AM
Philco 630csx power cord
Have you opened up that plug? It may be that the third wire is connected to that brass stud on the side of the plug and ...Arran — 02:57 AM
Model 27-84 BUZZ?Humm?
I would have to look at the schematic but it's not uncommon in 1930s AC radios to have the negative of one filter cap co...Arran — 02:46 AM
Model 27-84 BUZZ?Humm?
Hello Bruce, First all do mean a 37-84b ? Did you take any before and after pictures ? is it a buzz like when you touch...radiorich — 01:59 AM
B&K 1077B no video - problem solved
Hello Tim, Yes, I even check all of my replacement parts when I install them and I too had a capacitor go bad not long a...radiorich — 01:54 AM
B&K 1077B no video
I got back into it tonight. Problem found and resolved! Sometimes it helps to take a break and think things over. It was...TV MAN — 12:40 AM
6TPZ and 5TPO Radio Help
Thank you. I have to take a break from it for about a week. I'll have to do some thinking. I was toying with the idea ...R3Sons — 12:21 AM
Model 27-84 BUZZ?Humm?
Drowning in a overloud buzz/Humm. Have already changed filter caps,bakelite blocks( caps),out of speck resistors,checked...Bruce — 12:17 AM
Philco 630csx power cord
Hello Mike Here is the Link to the company the place is called Grand Brass lamp parts . I buy all my Lamp parts plus ...radiorich — 12:00 AM

[-]
Who's Online
There are currently 4037 online users. [Complete List]
» 3 Member(s) | 4034 Guest(s)
AvatarAvatarAvatar

>