Tale of a Z

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Tale of a Z

morzh
Odobenus rosmarus

Posts: 16,273
Threads: 566
Joined: Oct 2011
City: Jackson State, Province, Country: NJ

#10

02-06-2014, 04:35 PM

No....this type of restoration takes a whole new level of boldness...the one I don't possess.
My hat's off to you Brenda, I would fully forgo this radio.

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Tale of a Z - by BrendaAnnD - 02-06-2014, 12:55 AM

RE: Tale of a Z - by OldRestorer - 02-06-2014, 08:49 AM

RE: Tale of a Z - by TA Forbes - 02-06-2014, 10:07 AM

RE: Tale of a Z - by BrendaAnnD - 02-06-2014, 10:26 AM

RE: Tale of a Z - by morzh - 02-06-2014, 10:38 AM

RE: Tale of a Z - by TA Forbes - 02-06-2014, 10:40 AM

RE: Tale of a Z - by morzh - 02-06-2014, 10:53 AM

RE: Tale of a Z - by exray - 02-06-2014, 11:53 AM

RE: Tale of a Z - by BrendaAnnD - 02-06-2014, 04:03 PM

RE: Tale of a Z - by morzh - 02-06-2014, 04:35 PM

RE: Tale of a Z - by BrendaAnnD - 02-06-2014, 09:03 PM

RE: Tale of a Z - by morzh - 02-06-2014, 09:08 PM

RE: Tale of a Z - by Arran - 02-07-2014, 12:14 AM

RE: Tale of a Z - by BrendaAnnD - 02-07-2014, 02:57 AM

RE: Tale of a Z - by Conelrad - 02-07-2014, 07:51 AM

RE: Tale of a Z - by keithw - 02-07-2014, 10:56 AM

RE: Tale of a Z - by morzh - 02-07-2014, 10:58 AM

RE: Tale of a Z - by BrendaAnnD - 02-07-2014, 01:19 PM

RE: Tale of a Z - by BrendaAnnD - 02-07-2014, 01:25 PM

RE: Tale of a Z - by hsusmann - 02-07-2014, 11:53 PM

RE: Tale of a Z - by Arran - 02-08-2014, 05:15 AM

RE: Tale of a Z - by BrendaAnnD - 02-08-2014, 05:45 AM

RE: Tale of a Z - by hsusmann - 02-08-2014, 08:45 AM

RE: Tale of a Z - by BrendaAnnD - 02-08-2014, 10:17 AM

RE: Tale of a Z - by BrendaAnnD - 02-09-2014, 04:05 AM

RE: Tale of a Z - by hsusmann - 02-09-2014, 09:13 AM

RE: Tale of a Z - by BrendaAnnD - 02-09-2014, 09:33 AM

RE: Tale of a Z - by hsusmann - 02-09-2014, 09:40 AM

RE: Tale of a Z - by morzh - 02-09-2014, 12:34 PM

RE: Tale of a Z - by wireless - 02-09-2014, 01:21 PM

RE: Tale of a Z - by Tom Hamilton - 02-11-2014, 01:51 PM

RE: Tale of a Z - by TA Forbes - 02-18-2014, 12:51 PM

RE: Tale of a Z - by BrendaAnnD - 02-20-2014, 09:14 AM

RE: Tale of a Z - by Tom Hamilton - 02-20-2014, 10:21 AM

RE: Tale of a Z - by morzh - 02-20-2014, 11:05 AM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me