Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New acquisition, Philco 655B
#5

Somebody sure did strip the panel. The veneer looks pretty good as it sits.You should be able to wash off the stain on it with lacquer thinner. Couldn't see the sides, but if they aren't walnut veneer, then Philco used toned lacquer on that part. Don't fret about the Philco decal being missing. I have some advice about that. PM me at your convenience.

The grille cloth looks right, from your picture. Probably a bath in Renuzit will make it purty again.

Bandswitch knob looks like an early model, though. I'm beginning to be confused about that. On my late 116B, it has the bar knob. On the 640X that my aunt and uncle bought new in November, 1935, and that I have now, it had the round knob. I'd surely like to get straightened out on that!

I think I have a 645, but the finish is very light. You could call it blonde, even. I had to refinish it, and it came out exactly as it had been. These round topped tombstones must have come out late in the '36 model year (Ron would know). I also have this cabinet design in a 37-650 (as well as a 37-650X). It's a lot of radio for a table set.

This is just another one of the championship-performing Philcos. Yoiu can always count on being ecstatic at their operation when you get them done.


Messages In This Thread
New acquisition, Philco 655B - by BDM - 08-08-2008, 03:13 PM
[No subject] - by etech - 08-08-2008, 03:28 PM
[No subject] - by philco phan - 08-08-2008, 05:13 PM
[No subject] - by BDM - 08-08-2008, 05:48 PM
[No subject] - by Doug Houston - 08-09-2008, 12:32 AM
[No subject] - by BDM - 08-09-2008, 01:02 AM
[No subject] - by Texasrocker - 08-09-2008, 01:55 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM
6TPZ and 5TPO Radio Help
I suspect it's been repaired before. And I suspect whoever repaired it, wanted to re-use old transistors' pin stubs in o...morzh — 09:24 PM

[-]
Who's Online
There are currently no members online.

>