1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
49-501 question
tubenutt
Junior Member
**
Posts: 49
Threads: 18
Joined: Mar 2008
#1

08-13-2008, 10:45 PM
Hey, Philcophiles!
I have a question for our resident Philco gurus. I'm going through a 49-501 "boomerang" right now.
In going over the schematic, I notice that C303, a "special" capacitor, .2 mf at 400v, the cap that goes from the B- to chassis ground, is shown with an inductor in series with this capacitor.
Does that cap REALLY have an
And how should I go about replacing this "special condenser"?

I am almost done with that MONSTER 16B. What an excersize in tediousness! All of a sudden, I have no OUTPUT!
In troubleshooting, I found the output trans and the feild coil/input choke is shorted together!! All four connections !
I'm hoping I can remove the speaker and spread these wires apart to take care of the short. Anyone else ever run into this?
Steve McDonald
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
49-501 question - by tubenutt - 08-13-2008, 10:45 PM
[No subject] - by wonderwrench - 08-13-2008, 11:07 PM
[No subject] - by tubenutt - 08-14-2008, 02:53 AM
[No subject] - by wonderwrench - 08-14-2008, 11:41 AM
[No subject] - by tubenutt - 08-14-2008, 12:10 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently 6239 online users. [Complete List]
» 1 Member(s) | 6238 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration