Old tubes

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Old tubes

Eliot Ness
Phorum Expert

Posts: 3,145
Threads: 55
Joined: Apr 2011
City: Lexington, KY

#12

06-17-2014, 07:35 AM

The ultimate test is using a tube in circuit, so it sounds like your 47's and doing fine. If you're not sure who tested them I wouldn't worry about the 400 and 1000 Mhos marked on them. While the Knight is a simple emission type tube tester, it sounds like they tested fairly close and in the good range.

The calibration of the Knight 600 is pretty simple and the manual is located here (600tube.pdf):

http://bama.edebris.com/manuals/knight/600tube/

Replace any caps and out of tolerance resistors and the calibration for your simple tester sounds pretty easy.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Old tubes - by fields 100 - 06-13-2014, 06:06 AM

RE: Old tubes - by Eliot Ness - 06-13-2014, 09:04 AM

RE: Old tubes - by fields 100 - 06-13-2014, 09:47 AM

RE: Old tubes - by TA Forbes - 06-13-2014, 01:22 PM

RE: Old tubes - by Randy H. - 06-13-2014, 03:29 PM

RE: Old tubes - by fields 100 - 06-13-2014, 06:18 PM

RE: Old tubes - by Arran - 06-14-2014, 03:32 AM

RE: Old tubes - by Randy H. - 06-16-2014, 05:08 PM

RE: Old tubes - by Phlogiston - 06-16-2014, 07:42 PM

RE: Old tubes - by Phlogiston - 06-16-2014, 08:20 PM

RE: Old tubes - by fields 100 - 06-16-2014, 08:44 PM

RE: Old tubes - by Eliot Ness - 06-17-2014, 07:35 AM

RE: Old tubes - by codefox1 - 06-18-2014, 03:34 PM

RE: Old tubes - by Phlogiston - 06-18-2014, 03:40 PM

RE: Old tubes - by Tom Hamilton - 07-12-2014, 04:22 PM

View a Printable Version

Users browsing this thread: 6 Guest(s)

Recent Posts
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM

Who's Online

There are currently 6067 online users. [Complete List]
» 2 Member(s) | 6065 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me