Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Stromberg Carlson 225-H restoration chronicles
#3

That's Mike's Stromberg cabinet isn't it? I thought that was some species of rosewood, the Canadian General Electric KL500 cabinets used Santos Rosewood as a trim piece, which has red rays in the grain. Some Americans think that they were made by Ingraham like some Emerson and American G.E cabinets were, but I very much doubt that. I have a table that looks like they used the Brazilian kind, I need to do some work to it, someone did a crappy refinish job on it at one time. It looks like the grain in the veneer is pretty straight along that edge, not many rays in the grain, I would think that cutting a parallel strip off that edge and patching it that way would work best rather then trying to fit and fit one just at the back corner.
Regards
Arran


Messages In This Thread
RE: Stromberg Carlson 225-H restoration chronicles - by Arran - 07-02-2014, 10:52 PM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM

[-]
Who's Online
There are currently 5959 online users. [Complete List]
» 3 Member(s) | 5956 Guest(s)
AvatarAvatarAvatar

>