Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 89/19
#16

Thanks geek. Finally had time to work on this thing some today. Have changed filter caps, some other small caps and a few resistors out of tolerance. The radio played this afternoon dimly on BC band. I got 4 stations from 930 kH on up, one a little stronger than the other. Apparently the oscillator coil is OK. Just for kicks I switched it to SW and got one station -- even in the afternoon--about 3.5 mHz --- LOUDER than the BC band came in. So it's progress but have a ways to go on it. I switched out tubes that were either dead or very weak except for the rectifier. That's next....maybe tonight. At least I didn't kill the radio...yet!!Icon_lol


Messages In This Thread
Philco 89/19 - by Art Hoch - 05-30-2014, 10:52 AM
RE: Philco 89/19 - by Ron Ramirez - 05-30-2014, 12:58 PM
RE: Philco 89/19 - by exray - 05-31-2014, 05:18 AM
RE: Philco 89/19 - by morzh - 05-31-2014, 10:51 AM
RE: Philco 89/19 - by PAradiogeek - 05-31-2014, 03:54 PM
RE: Philco 89/19 - by Art Hoch - 06-02-2014, 09:47 PM
RE: Philco 89/19 - by gregb - 06-02-2014, 11:05 PM
RE: Philco 89/19 - by PAradiogeek - 06-03-2014, 12:42 AM
RE: Philco 89/19 - by Art Hoch - 06-03-2014, 02:16 PM
RE: Philco 89/19 - by gregb - 06-03-2014, 02:28 PM
RE: Philco 89/19 - by Chuck Schwark - 06-03-2014, 03:10 PM
RE: Philco 89/19 - by Art Hoch - 06-05-2014, 09:32 PM
RE: Philco 89/19 - by Art Hoch - 06-26-2014, 03:55 PM
RE: Philco 89/19 - by Art Hoch - 07-02-2014, 10:49 PM
RE: Philco 89/19 - by PAradiogeek - 07-06-2014, 03:21 PM
RE: Philco 89/19 - by Art Hoch - 07-09-2014, 06:00 PM
RE: Philco 89/19 - by Randy H. - 07-12-2014, 06:14 PM
RE: Philco 89/19 - by Art Hoch - 07-12-2014, 08:57 PM
RE: Philco 89/19 - by Art Hoch - 07-14-2014, 10:44 AM
RE: Philco 89/19 - by Ron Ramirez - 07-14-2014, 10:45 AM
RE: Philco 89/19 - by Art Hoch - 07-14-2014, 08:19 PM
RE: Philco 89/19 - by Art Hoch - 07-23-2014, 12:24 PM
RE: Philco 89/19 - by Ron Ramirez - 07-23-2014, 12:36 PM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM

[-]
Who's Online
There are currently 10214 online users. [Complete List]
» 1 Member(s) | 10213 Guest(s)
Avatar

>