Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

U.S.Radio & Television Corp- Model 80
#2

Hello Dave! Welcome! I have restored several Majestics before. Your set (Majestic mod 80) is known as a early "trf" set. I did some research in my JF Riders, and found that your set has the same tube "lineup", as the Majestic models 70 & 71B in the Grigsby-Grunow pages of JF Riders early schematics. You can also use Nostalgiaair dot org to find this schematic if you dont have it. Capacitor info for these early sets can also be found in your JF Riders pages covering "Majestic" radios in the "Grigsby Grunow" pages. They also made the Majestic Chassis for US Radio & Television. Riders vol 1 is "vague", but you can also use the Grigsby-Grunow pages to supplement your capacitors-ratings info!

Your Majestic mod 80 set uses (5) # 26 tubes in various stages of RF & 1st AF, (1) # 27 detector tube, (2) #71 push-pull output audio, & (1) # 80 rectifier tube, same as the Majestic models 70 & 70B.

Using the capacitors data from the "Grigsby-Grunow Company" JF Riders pages, instead of the JF Riders US Radio & Television pages, should most definately get you in the ballpark for caps ratings! These early TRF sets were "very- forgiving" for recaps!

As a general rule, the electrolytic filter caps in these early TRF type sets had a high voltage rating,but low UF ratings in most cases! I would say 10 ufs@ 500 volts would be more than plenty for replacements in the Majestic power-supply units.

If you have anymore questions or need further help, Im located only 3.5 hrs from you in San Angelo. I can get your radio working again, and/or, show you how & what parts are needed. Sometimes, the "chokes" and/or the filament trans 2.5 v are "open" (bad) in these type early trfs sets also. Easy fix tho if needed! Icon_wink


Messages In This Thread
U.S.Radio & Television Corp- Model 80 - by Dave D - 09-06-2008, 12:38 PM
Re: U.S.Radio & Television Corp- Model 80 - by Texasrocker - 09-10-2008, 03:06 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Since these radios operated in harsh environments (temp changes and vibration) you could touch a soldering iron to all t...GarySP — 03:18 PM
6TPZ and 5TPO Radio Help
Thank you Gary. Hi Morzh. These radios are 6 transistor radios. Sadly no tubes. Thanks though.R3Sons — 02:19 PM
Heathkit Sweep Generator TS-4
Ron Instead of Quick reply, go to New Reply, then go to the title of the very first post, and change the title text the...morzh — 02:00 PM
6TPZ and 5TPO Radio Help
I am not a specialist in car radios. I suspect they might use vibrators to convert 12V to acceptable tube voltages, so ...morzh — 01:58 PM
6TPZ and 5TPO Radio Help
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM

[-]
Who's Online
There are currently 8164 online users. [Complete List]
» 1 Member(s) | 8163 Guest(s)
Avatar

>