Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 42-380X Reception problems
#14

Dave,

Re: 29A and 29B, I can only refer to the John Rider alignment instructions that are on Nostalgia Air. Those instructions say to adjust 29A and then 29B in that order. I assume you have downloaded these free pages from Nostalgia air: http://www.nostalgiaair.org/PagesByModel...013533.pdf

It is very hard to read, but it looks like 29A is an adjustable inductor in the transformer # 29, and 29B is an adjustable capacitor on the secondary side. As Chuck mentioned, the Philco factory alignment instructions might differ. I don't have access to those instructions for this radio.

Assuming compensators 34A, 31A, 29A, and 29B are adjusted properly in that order, with a signal generator, then you should get the best sensitivity with any given antenna. If your sensitivity is still not good, try the loop antenna in the cabinet, and then I'd suspect a tube or other component in the chassis.

Did you replace the 41 tubes that you already think are bad? The AES tube sale goes through Sept. 30. I might buy a couple of 41s myself.

John Honeycutt


Messages In This Thread
Philco 42-380X Reception problems - by David B - 09-14-2008, 09:51 AM
Re: Philco 42-380X Reception problems - by Raleigh - 09-24-2008, 04:10 PM



Users browsing this thread: 7 Guest(s)
[-]
Recent Posts
91H Code 126 Restore
I'm pretty sure that the dotted line I circled in an earlier post signifies that it is applicable to the 226 model which...RealRider — 08:05 AM
Philco 49-1040
Hello bob, that underside looks like it is all original ! Sincerely Richardradiorich — 02:07 AM
Philco 49-1040
Oh yes, many bumblebees and loktal tubes. The cutout is for the speaker.  Here's a photo from a different set. Bob Andersen — 12:59 AM
Philco 49-1040
Bob; Looks like another "Bumble Bee" special, like my Brand Z T.O radios. Is that section they took out of ...Arran — 12:19 AM
Philco 49-1040
Hello Bob, You are like the home for lost tv's like how people bring pets home ! Sincerely Richardradiorich — 12:00 AM
Philco 49-1040
I thought I had an arrangement to restore this set for a customer but his wife said heck no.  Instead, he gave it to me....Bob Andersen — 10:29 PM
Philco 46-480 Electronic Restoration
I kept working on reassembly this week. I wasn’t able to solder for a few days while it was too cold (single digit low t...jrblasde — 09:27 PM
Atwater-Kent 84, restoration.
Well, powering it up would be too good to be true, and I had that feeling. Before I did, I decided to check the coils...morzh — 06:02 PM
An attempt to remove the Field Coil from a G speaker
Thanks Chas, sure will give it a look!morzh — 03:39 PM
An attempt to remove the Field Coil from a G speaker
Mike, Lookup  murrayatuptown on ARF. Seems he has a dilemma with surplus field coils. Could get lucky and have what y...Chas — 01:26 PM

[-]
Who's Online
There are currently 2369 online users. [Complete List]
» 2 Member(s) | 2367 Guest(s)
AvatarAvatar

>