Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

531 Questions
#2

I have one of these sets and can answer a few questions. Of course the first thing to tell you is: DON'T PLUG IT IN! That's the first rule of thumb with these old radios until they can be checked out properly. Those hinges acutally are original (mine has them as well) and are actually used as stops to keep you from accidentally pulling the chassis totally out the front! Basically, you would unplug the speaker wires, flip those hinges up, and then you can carefully pulle the chassis totally out from the front. The back on mine has holes so you can reach those hinges without pulling the back off.

No matter where you go, there you are.


Messages In This Thread
531 Questions - by krispaul - 09-23-2014, 09:25 PM
RE: 531 Questions - by Jayce - 09-25-2014, 01:19 AM
RE: 531 Questions - by klondike98 - 09-25-2014, 08:12 PM
RE: 531 Questions - by exray - 09-25-2014, 09:49 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM

[-]
Who's Online
There are currently 7110 online users. [Complete List]
» 3 Member(s) | 7107 Guest(s)
AvatarAvatarAvatar

>