Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Question about a 53-960
#15

I handle plenty of the old (phenolic paper, the brown ones) PCBs in mybyounger years.
The last one was when I fixed that Philco portable transistor record player.
Yep, very bad.

Beleve itbor not but much of consumer electronics in the SU used that material well into 80s.
My stereo for one used it. Made in 1979.


Messages In This Thread
Question about a 53-960 - by Kekoa - 10-26-2014, 12:09 AM
RE: Question about a 53-960 - by sam - 10-26-2014, 12:16 AM
RE: Question about a 53-960 - by Ron Ramirez - 10-26-2014, 08:36 AM
RE: Question about a 53-960 - by radiohenry - 10-26-2014, 11:24 AM
RE: Question about a 53-960 - by Kekoa - 10-26-2014, 11:27 AM
RE: Question about a 53-960 - by OZ4 - 10-26-2014, 12:41 PM
RE: Question about a 53-960 - by Kekoa - 10-26-2014, 04:13 PM
RE: Question about a 53-960 - by Ron Ramirez - 10-26-2014, 04:20 PM
RE: Question about a 53-960 - by Kekoa - 10-26-2014, 05:47 PM
RE: Question about a 53-960 - by Kekoa - 10-27-2014, 12:29 PM
RE: Question about a 53-960 - by morzh - 10-27-2014, 10:13 PM
RE: Question about a 53-960 - by Arran - 10-28-2014, 12:02 AM
RE: Question about a 53-960 - by Kekoa - 10-28-2014, 10:11 AM
RE: Question about a 53-960 - by Kekoa - 11-02-2014, 09:12 PM
RE: Question about a 53-960 - by morzh - 11-02-2014, 09:27 PM
RE: Question about a 53-960 - by Kekoa - 11-03-2014, 12:36 PM
RE: Question about a 53-960 - by Kekoa - 11-06-2014, 01:30 AM
RE: Question about a 53-960 - by sam - 11-06-2014, 03:52 AM
RE: Question about a 53-960 - by Kekoa - 11-08-2014, 09:52 PM
RE: Question about a 53-960 - by Ron Ramirez - 11-08-2014, 11:43 PM
RE: Question about a 53-960 - by Kekoa - 11-15-2014, 11:48 AM
RE: Question about a 53-960 - by morzh - 11-15-2014, 11:55 AM
RE: Question about a 53-960 - by Kekoa - 11-15-2014, 12:09 PM
RE: Question about a 53-960 - by morzh - 11-15-2014, 03:31 PM
RE: Question about a 53-960 - by Ron Ramirez - 11-15-2014, 09:14 PM
RE: Question about a 53-960 - by Kekoa - 11-15-2014, 10:17 PM



Users browsing this thread: 12 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently 7137 online users. [Complete List]
» 1 Member(s) | 7136 Guest(s)
Avatar

>