Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-180 Cabinet and Buttons
#2

 I think that you may have to strip the top and the control panel, the lacquer on top looks like it's dead and flaking off due to water damage, plus it looks like there is a burn mark, trying to touch up things like that never looks quite right, you may want to strip the shoulder sections on top as well, for similar reasons. It's a common problem with any old console that was left to the clutches of silly housewives who insisted on putting potted plants on top of radio cabinets, or from drinkers and smokers using the radio cabinet as a bar top and or ashtray. Now if you are careful you can strip around the decals to save them, though they are readily available from Radio Daze. To get those panels to match the rest you will have to use a light walnut tone spray, the dye based type, for the base of the cabinet it was either medium walnut or perfect brown, again dye based.  
Regards
Arran


Messages In This Thread
40-180 Cabinet and Buttons - by mgambuzza - 11-02-2014, 09:56 AM
RE: 40-180 Cabinet and Buttons - by Arran - 11-04-2014, 01:40 AM
RE: 40-180 Cabinet and Buttons - by Raleigh - 11-18-2014, 01:04 AM
RE: 40-180 Cabinet and Buttons - by Edisla - 11-21-2014, 09:02 PM
RE: 40-180 Cabinet and Buttons - by klondike98 - 11-21-2014, 11:37 PM
RE: 40-180 Cabinet and Buttons - by Edisla - 11-22-2014, 01:27 AM
RE: 40-180 Cabinet and Buttons - by Edisla - 11-22-2014, 01:32 AM
RE: 40-180 Cabinet and Buttons - by Arran - 11-22-2014, 02:00 AM
RE: 40-180 Cabinet and Buttons - by Edisla - 11-22-2014, 02:31 AM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM

[-]
Who's Online
There are currently 9763 online users. [Complete List]
» 2 Member(s) | 9761 Guest(s)
AvatarAvatar

>