Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-61 problems
#12

That would be one of their All-wave antennas that are like a multi-band dipole. Simply an option that they sold. Not really at issue here.

I really got my story bungled on the above post. I pulled out my 37-60 a while ago. Thats the one in which I used a ferrite toroid to replace a missing OSC coil. The 60 and 61 are quite similar, however, at least for BCB. I poked around looking to see what additional clues I could come up with and I've run out of ideas. I cannot help but think that the coil somehow is the culprit here.

Backtracking on an earlier path...you mentioned having to take the AVC loose when doing the coil-to-ground test. I was reviewing that and see that you would have measured about 2 Megs to ground. Is that pretty much the ballpark range of what you saw with the AVC connected? Something else I wish I had thought to check while I had my chassis out of the cabinet and thats the method of grounding the subchassis to the main chassis. What I'm getting at here is making sure that cap #4 finds a good rf ground.

How well does the shortwave work? Do you notice any dropoff on the low end of that band?


Messages In This Thread
Philco 37-61 problems - by Guest - 11-26-2008, 09:43 PM
Re: Philco 37-61 problems - by exray - 11-27-2008, 07:43 AM
Re: Philco 37-61 problems - by Guest - 11-27-2008, 09:01 AM
Re: Philco 37-61 problems - by exray - 11-27-2008, 09:15 AM
Re: Philco 37-61 problems - by Guest - 11-27-2008, 10:05 AM
Re: Philco 37-61 problems - by exray - 11-27-2008, 10:29 AM
Re: Philco 37-61 problems - by Guest - 11-27-2008, 11:07 AM
Re: Philco 37-61 problems - by Guest - 11-27-2008, 11:30 AM
Re: Philco 37-61 problems - by Guest - 11-27-2008, 12:16 PM
Re: Philco 37-61 problems - by exray - 11-27-2008, 12:21 PM
Re: Philco 37-61 problems - by Guest - 11-27-2008, 05:26 PM
Re: Philco 37-61 problems - by exray - 11-27-2008, 07:45 PM
Re: Philco 37-61 problems - by wonderwrench - 11-27-2008, 08:04 PM
Re: Philco 37-61 problems - by exray - 11-27-2008, 08:31 PM
Re: Philco 37-61 problems - by Guest - 11-27-2008, 10:03 PM
Re: Philco 37-61 problems - by Guest - 11-29-2008, 06:04 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM
RCA 15X
Everthing goes at once, maybe it's the cold weather, I have had 2 dial strings break and no my little RCA is having dial...Paul Philco322 — 10:26 PM
Philco 91 Schematic
Hi Dan, I can't explain this specific resistor but I have seen the use of a switch to apply B+ voltage to screen gri...RodB — 09:36 PM

[-]
Who's Online
There are currently 6597 online users. [Complete List]
» 2 Member(s) | 6595 Guest(s)
AvatarAvatar

>