Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-81T my next project
#6

My 41-81T is done. I finally made the new handle for it. I ordered a brown goat skin from eBay. but didn't get to the sewing store until today to get leather needles for my old Pfaff 130. Today I made the handle, pretty simple, five thicknesses of leather wrapped so that the final layer ends on the bottom, and the loops for the rings are double thickness. The only hard part is with work that thick, one has to lift the presser foot with each stitch, and reposition the work by hand. It isn't perfect, but it is better than the worn through, broken original.

Tonight I tested it out. The sunspots must have been kicking up some strange skip, because I was receiving a lot of Central American stations, and far away US stations too, like WTCS, a little 1000 watt station down in Fairmont, WV. Not bad on the built in antenna from here in Providence.

I cleaned the fabric covering with gentle detergent and water on a sponge, and dried it well and quickly. I also polished the leatherette with brown leather polish. This is the final product.

[Image: https://38.media.tumblr.com/135b56a78bdb...2_1280.jpg]


Messages In This Thread
41-81T my next project - by mikethedruid - 10-11-2014, 03:27 PM
RE: 41-81T my next project - by klondike98 - 10-11-2014, 09:21 PM
RE: 41-81T my next project - by Ron Ramirez - 10-11-2014, 09:46 PM
RE: 41-81T my next project - by mikethedruid - 10-11-2014, 11:36 PM
RE: 41-81T my next project - by morzh - 10-12-2014, 02:47 PM
RE: 41-81T my next project - by mikethedruid - 12-18-2014, 03:18 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM

[-]
Who's Online
There are currently 9765 online users. [Complete List]
» 3 Member(s) | 9762 Guest(s)
AvatarAvatarAvatar

>