1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 90 later version
morzh
Odobenus rosmarus
******
Posts: 16,217
Threads: 562
Joined: Oct 2011
City: Jackson State, Province, Country: NJ
#15

12-20-2014, 12:32 AM
Murf

I ain't sure no more but the component you are showing looks an awful lot like a volume regulator potentiometer, not the tone switch.

Now if it is the case (it is part # 20) you have one end grounded, the middle one goes to 27 tube DET AMP's grid, and the third pin (you are holding the wire from it) goes to where caps 18 and 19 connect together.
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 90 later version - by murf - 12-14-2014, 12:07 AM
RE: Philco 90 later version - by Ron Ramirez - 12-14-2014, 10:05 AM
RE: Philco 90 later version - by murf - 12-14-2014, 10:17 AM
RE: Philco 90 later version - by murf - 12-15-2014, 09:45 PM
RE: Philco 90 later version - by KCMike - 12-15-2014, 11:27 PM
RE: Philco 90 later version - by Steve Davis - 12-15-2014, 11:50 PM
RE: Philco 90 later version - by murf - 12-16-2014, 11:10 AM
RE: Philco 90 later version - by morzh - 12-16-2014, 11:38 PM
RE: Philco 90 later version - by murf - 12-17-2014, 11:22 PM
RE: Philco 90 later version - by morzh - 12-18-2014, 12:08 AM
RE: Philco 90 later version - by Steve Davis - 12-18-2014, 12:38 PM
RE: Philco 90 later version - by murf - 12-18-2014, 10:21 PM
RE: Philco 90 later version - by morzh - 12-19-2014, 04:13 PM
RE: Philco 90 later version - by morzh - 12-19-2014, 04:18 PM
RE: Philco 90 later version - by morzh - 12-20-2014, 12:32 AM
RE: Philco 90 later version - by murf - 12-20-2014, 01:16 PM
RE: Philco 90 later version - by murf - 01-13-2015, 11:19 AM
RE: Philco 90 later version - by murf - 01-14-2015, 11:49 PM
RE: Philco 90 later version - by morzh - 01-15-2015, 12:09 AM
RE: Philco 90 later version - by Ron Ramirez - 01-15-2015, 07:12 AM
RE: Philco 90 later version - by murf - 01-15-2015, 08:48 PM
RE: Philco 90 later version - by murf - 02-01-2015, 03:32 PM
RE: Philco 90 later version - by klondike98 - 02-01-2015, 04:03 PM
RE: Philco 90 later version - by murf - 02-01-2015, 04:14 PM
RE: Philco 90 later version - by klondike98 - 02-01-2015, 04:17 PM
RE: Philco 90 later version - by murf - 02-02-2015, 11:10 PM
RE: Philco 90 later version - by morzh - 02-02-2015, 11:39 PM
RE: Philco 90 later version - by murf - 05-07-2015, 05:42 PM
RE: Philco 90 later version - by klondike98 - 05-07-2015, 05:53 PM
RE: Philco 90 later version - by morzh - 05-07-2015, 08:23 PM
RE: Philco 90 later version - by klondike98 - 05-07-2015, 08:39 PM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM

[-]
Who's Online
There are currently 6175 online users. [Complete List]
» 3 Member(s) | 6172 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration