[Ron Ramirez]

Thank you, John (Eliot), Sam, and Greg - great suggestions all. After Christmas is over, I'll look for something thin to use as backing material.

In my online research this morning, I discovered that there is a two-part epoxy similar to J-B Weld, made for aluminum - Alum-Bond. Maybe some of that stuff, together with some sort of backing to give the broken joints extra strength, will do the trick? I think if I had not tried to remove the excess J-B, it would have held...but for how long? I agree that reinforcing the glued joints is necessary; I just wasn't sure how to go about it.

And Sam, I may still want to make a mold and make a plastic duplicate, after I get the original back together, just in case

The radio looks pretty sad right now with just one center grillebar:

[Image: http://www.philcoradio.com/images/phorum...e00015.jpg]

Now that the cloth is in the cabinet, I see that I didn't get the cloth completely straight. But it's straighter than that shown in the factory Philco illustration above, so it will do.