Here we go with a Brand Z 9-S-262
Posts: 479
Threads: 73
Joined: Mar 2012
City: Riverside, CA
(01-03-2015, 11:00 PM) Ron Ramirez Wrote: Geoff
Point taken. Once I settled into a good groove working on this Zenith, I found that it wasn't that difficult after all. Hopefully, replacing those AM band leaves won't be too hard, either. I have the Goller method thanks to John (Eliot) which I will print out when I am ready to tackle that job.
I might of used the same method. Here is a copy that I got, probably from Goller, but I forget since it was awhile ago.
- Geoff
Attached Files
Messages In This Thread
RE: Here we go with a Brand Z 9-S-262 - by Geoff - 01-05-2015, 02:51 PM
Users browsing this thread: 22 Guest(s)
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary
I in fact did, on a 38-14, I think, where I had a speaker with the dead coil.
Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is.
The green stuff. Unfortunately, probably penetrates deep.
I opened the top layer and saw that:
...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap:
Really nice workmanship!!! Top of the chassis looks great.
Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr
Yes, it is my plan to go with 45rpm spider if I go that far.
No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network.
Are any other tubes experience the drop or just this?`
Is resistor 23 OK...morzh — 07:09 PM
Who's Online
There are currently no members online.