Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Canadian Philco 37-3116 Capacitor Question
#6

 There would have been a 25 cycle version of the 37-116 sets, I'm not sure if they still added the suffix "A" after the model number. Point in fact there were 60 and 25 cycle versions produced in Canada and in the U.S, if you look at most period advertising for the Canadian market they offered 25 cycle versions of most makes and models at an extra cost, although Rogers built sets seem to have all been built with 25 cycle power supplies. The extra  capacitors, were added for extra filtering to contend with the coarser ripple, these days you could probably leave them out to no ill effect since there are no 25 cycle power systems anymore, yes I think using 630 volt film capacitors will work, if you want to bother with them. Most of the 25 cycle versions of other radios I've seen just enlarged the capacitance of the main filter caps, or added an extra one, they didn't normally shunt a lower value cap across a filter choke. 
Regards
Arran


Messages In This Thread
RE: Canadian Philco 37-3116 Capacitor Question - by Arran - 01-06-2015, 01:15 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM

[-]
Who's Online
There are currently 10000 online users. [Complete List]
» 2 Member(s) | 9998 Guest(s)
AvatarAvatar

>