Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

So where should I start.... Philco 38-116
#28

Yes Terry you are correct, the pictures are where the tubes where when I got it and the 5x tube was not installed in the right place. I reinstalled all of the tubes in the correct locations and did another dim bulb test tonight and this time it burned brightly and never dimmed. I also did with with all the tubes out except the rectifier plugged in and this also burned brightly never dimming, so I took everything out. Even before I turned anything on the rectifier tube never passed the tube continuity checker so it is probably dead. Unplugged all of the tubes and put them in a box (except the one that I accidentally broke when I knocked it on some metal) so I just worked on vacuuming and cleaning the chassis.

Jerry couple of questions on 1. above. When you say meter, I have a digital volt ohm meter that they sell at every hardware store, will that one work, I believe it is Cen-tech 7 function?


Messages In This Thread
RE: So where should I start.... Philco 38-116 - by louxwe - 03-06-2015, 02:19 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM

[-]
Who's Online
There are currently no members online.

>