Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 39-30 Questions
#5

(03-18-2015, 10:46 AM)Eric Wrote:  Went into vol. X and looked at other Philco's with a terminal for ground and not a one shows a cap there so I will remove it.

Yeah, I'd remove it too.  When you replace the two .01's that were #41 you want to use safety caps since they are going from line to ground.  I use X1/Y2 caps like those in the link, but I got mine at Mouser:

http://www.justradios.com/X1Y2capacitors.html

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"


Messages In This Thread
Philco 39-30 Questions - by Eric - 03-18-2015, 09:46 AM
RE: Philco 39-30 Questions - by Eliot Ness - 03-18-2015, 10:14 AM
RE: Philco 39-30 Questions - by Eric - 03-18-2015, 10:26 AM
RE: Philco 39-30 Questions - by Eric - 03-18-2015, 10:46 AM
RE: Philco 39-30 Questions - by Eliot Ness - 03-18-2015, 11:03 AM
RE: Philco 39-30 Questions - by Eric - 03-18-2015, 11:23 AM
RE: Philco 39-30 Questions - by Radioroslyn - 03-18-2015, 04:29 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM

[-]
Who's Online
There are currently 6036 online users. [Complete List]
» 2 Member(s) | 6034 Guest(s)
AvatarAvatar

>