1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco Model 20 1930 Lowboy
GarySP
Super Moderator
******
Posts: 2,078
Threads: 154
Joined: Jan 2013
City: Westland, MI
#15

05-31-2015, 09:26 PM
The filter can isn't as bad as it looks.  Two screws on top come out from the top of the chassis on each mounting tab and the can will lift away from the chassis.  You can then clip the feed wires and remove the can completely.  With mine I propped the can up by the mounting tabs over a metal coffee can.  I then placed it about a foot in front of my 35000 btu garage torpedo heater.  After about 5 minutes the tar softened and slid right out of the can into the coffee can.  A good heat gun could probably do the job, just take a little longer.  DO NOT DO THIS IN THE HOUSE IN YOUR OVEN!!!  The fumes produced will stay with you for some time to come.  Definitely an outdoor project.  Also, order a copy of the schematic from Chuck Schwark .  Well worth the cost with all the information he provides with his packet.  Take care, Gary 
"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco Model 20 1930 Lowboy - by Crist Rigotti - 05-27-2015, 10:58 PM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-27-2015, 11:13 PM
RE: Philco Model 20 1930 Lowboy - by sam - 05-28-2015, 02:46 AM
RE: Philco Model 20 1930 Lowboy - by GarySP - 05-28-2015, 08:25 AM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-28-2015, 11:03 AM
RE: Philco Model 20 1930 Lowboy - by PhilcoJohn - 05-29-2015, 06:59 AM
RE: Philco Model 20 1930 Lowboy - by Art Hoch - 05-29-2015, 11:54 AM
RE: Philco Model 20 1930 Lowboy - by mikethedruid - 05-30-2015, 07:01 PM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-31-2015, 11:07 AM
RE: Philco Model 20 1930 Lowboy - by GarySP - 05-31-2015, 04:48 PM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-31-2015, 04:53 PM
RE: Philco Model 20 1930 Lowboy - by GarySP - 05-31-2015, 09:26 PM
RE: Philco Model 20 1930 Lowboy - by GarySP - 05-31-2015, 09:35 PM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-31-2015, 11:12 PM
RE: Philco Model 20 1930 Lowboy - by Fred Taylor - 06-01-2015, 08:01 AM
RE: Philco Model 20 1930 Lowboy - by morzh - 06-01-2015, 10:13 AM
RE: Philco Model 20 1930 Lowboy - by GarySP - 06-07-2015, 06:32 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM
Philco 89 indicator light.
I forgot how the pointer is formed: could you show the way it is formed and how you tried to change it?morzh — 07:01 PM
An attempt to remove the Field Coil from a G speaker
Was that pole piece left handed ? Since the metal "spider" is toast, wonder if you can either get the "4...MrFixr55 — 06:54 PM
Philco 91 Restore Code ??
Thank you Rod.  Hello MrFixr55. Thank you for the long reply. My radio is the 121 version (1 speaker) and I am aware ...dconant — 06:36 PM
Philco 91 Restore Code ??
Your 8 watt transformer is good, the 42s produce 6 watts and you won't be sending maximum volume to the speaker anyway. ...RodB — 05:54 PM

[-]
Who's Online
There are currently 3143 online users. [Complete List]
» 1 Member(s) | 3142 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios