1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Model 96 Field coil.....
Jim Koehler
Junior Member
**
Posts: 44
Threads: 4
Joined: Dec 2013
City: Freeport, LI, NY
#1

07-01-2015, 02:54 PM
Hi Guys......

On the bench is a model 96 and I'm having a few issues....

Is there a list for the resistor values?  Other than part numbers and Bintliff's Philco Cap Guide Pt. II, I was just wondering if a Philco list can be found.

Can someone furnish me with the resistance value of the field coil?  Mine's reading about 2,200 ohms DC. On a test, I had 334 VDC going into the FC and 150 VDC coming out. It should be about 225 VDC. Monitoring the amp draw of the radio, it's around 800 ma. I think this coil is shorted but knowing the actual resistance value would be a big help. (the cap can (p/n 3754) has been recapped and works fine. 

Tnx...
...Jim
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Model 96 Field coil..... - by Jim Koehler - 07-01-2015, 02:54 PM
RE: Model 96 Field coil..... - by morzh - 07-01-2015, 03:01 PM
RE: Model 96 Field coil..... - by Jim Koehler - 07-01-2015, 04:02 PM
RE: Model 96 Field coil..... - by morzh - 07-01-2015, 04:14 PM
RE: Model 96 Field coil..... - by Radioroslyn - 07-01-2015, 04:40 PM
RE: Model 96 Field coil..... - by morzh - 07-01-2015, 04:46 PM
RE: Model 96 Field coil..... - by codefox1 - 07-01-2015, 05:28 PM
RE: Model 96 Field coil..... - by Ron Ramirez - 07-01-2015, 07:54 PM
RE: Model 96 Field coil..... - by Radioroslyn - 07-01-2015, 08:36 PM
RE: Model 96 Field coil..... - by Jim Koehler - 07-01-2015, 08:47 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM

[-]
Who's Online
There are currently 5980 online users. [Complete List]
» 3 Member(s) | 5977 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration