Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

16b and model 20 pwr trans
#13

The cabinet is indeed a 16B...but I'd never seen a 5-band chassis in this cabinet before, only in the cathedral and the version of this cabinet with the less pronounced peak to the cabinet top.

Did you buy this radio? If so, tell me, is there a large hole behind the tuning knob? If so...then, definitely, the chassis has been switched. The 4-band version uses dual concentric tuning knobs, necessitating the large hole for the larger concentric tuning shafts. A 5-band chassis where a 4-band chassis should be...a 5Z3 in place of an 80...this points to a chassis swap to me.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
16b and model 20 pwr trans - by philco phan - 02-16-2009, 05:50 PM
Re: 16b and model 20 pwr trans - by Steve Davis - 02-16-2009, 06:52 PM
Re: 16b and model 20 pwr trans - by Ron Ramirez - 02-16-2009, 06:53 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-16-2009, 07:25 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-16-2009, 10:34 PM
Re: 16b and model 20 pwr trans - by Steve Davis - 02-16-2009, 10:58 PM
Re: 16b and model 20 pwr trans - by Ron Ramirez - 02-16-2009, 11:56 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-17-2009, 12:08 AM
Re: 16b and model 20 pwr trans - by philco phan - 02-17-2009, 01:28 AM
Re: 16b and model 20 pwr trans - by philco phan - 02-17-2009, 11:05 PM
Re: 16b and model 20 pwr trans - by Ron Ramirez - 02-18-2009, 12:06 AM
Re: 16b and model 20 pwr trans - by philco phan - 02-18-2009, 01:24 AM
Re: 16b and model 20 pwr trans - by Ron Ramirez - 02-18-2009, 07:11 AM
Re: 16b and model 20 pwr trans - by philco phan - 02-18-2009, 07:00 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-18-2009, 08:46 PM
Re: 16b and model 20 pwr trans - by radiomikee - 02-27-2009, 01:13 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-28-2009, 01:03 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM
RCA 15X
I'd try replacing the bulb first and if that doesn't do it, then change the 35Z5 and see if the problem goes away.NostalgiaRadioTime — 12:28 AM
B&K 1077B no video
Hello Tim, I have that exact unit in my shop too plus a Sencore unit there are times I like one or other !!. Sincerely...radiorich — 11:07 PM

[-]
Who's Online
There are currently 4067 online users. [Complete List]
» 1 Member(s) | 4066 Guest(s)
Avatar

>