Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

This was a hard decision...for me anyhow
#1

The Wisconsin Antique Radio Club swap meet was today, and despite the beautiful weather, vendor turn out was meager. I was just getting ready to leave when I saw a late comer just setting up and spotted this:

   

A 38-116. I asked the out-of-breath guy who just unloaded it from his van how much. He said $30. Wow....this seems to good to be true. Closer examination revealed a cabinet that needed total refinishing (my picture doesn't show the wear, dings, scratches, stains, etc.). I got to talking with him a little and said "At that price you basically are just looking to free up some space?" He said yes. I pressed on. "Has anyone started to restore this or has it been sitting for years?". "I started restoring it about 20 years ago". Hmmm...now it's getting clearer. I said "Did you run into some problems?" Yes came the response. "I recapped it but couldn't get very many stations back then and only at low volume. I just tried it again today and got nothing". So basically I got the sense that he messed something up and just left it sit. As much as I would like one of these, I'm afraid I would've been biting off more than I could chew. Even an original unmolested set is a challenge to restore. Coupled with that... miles of crumbling rubber covered wire (if only this was a 1937 or earlier). In the end, I decided against it. Another guy was going to trade him a 10 year old stereo system for it, so I knew he just wanted it out of the house. I wound up coming home with a Crosley "dashboard" table model instead.

Greg V.
West Bend, WI
Member WARCI.org





Users browsing this thread: 9 Guest(s)
[-]
Recent Posts
Model 27-84 BUZZ?Humm?
Depends on the type of hum. SOme is made by outside devices. Try installing an X-cap (0.2-0.5uF) across the AC line, ...morzh — 12:23 PM
Philco 40-120C Filament Wiring
Thank you for your replies. That is the correct schematic and pin out diagram for the rectifier. The resistance acro...bluecap — 11:01 AM
Philco 46-480 Electronic Restoration
Late last night a guy reached out in response to my posting on the Antique Radio Forum and suggested I contact Trust Aut...jrblasde — 11:01 AM
Philco 630csx power cord
Have you opened up that plug? It may be that the third wire is connected to that brass stud on the side of the plug and ...Arran — 02:57 AM
Model 27-84 BUZZ?Humm?
I would have to look at the schematic but it's not uncommon in 1930s AC radios to have the negative of one filter cap co...Arran — 02:46 AM
Model 27-84 BUZZ?Humm?
Hello Bruce, First all do mean a 37-84b ? Did you take any before and after pictures ? is it a buzz like when you touch...radiorich — 01:59 AM
B&K 1077B no video - problem solved
Hello Tim, Yes, I even check all of my replacement parts when I install them and I too had a capacitor go bad not long a...radiorich — 01:54 AM
B&K 1077B no video
I got back into it tonight. Problem found and resolved! Sometimes it helps to take a break and think things over. It was...TV MAN — 12:40 AM
6TPZ and 5TPO Radio Help
Thank you. I have to take a break from it for about a week. I'll have to do some thinking. I was toying with the idea ...R3Sons — 12:21 AM
Model 27-84 BUZZ?Humm?
Drowning in a overloud buzz/Humm. Have already changed filter caps,bakelite blocks( caps),out of speck resistors,checked...Bruce — 12:17 AM

[-]
Who's Online
There are currently no members online.

>