Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help with a Philco 89B
#18

Welcome to the phorum, Steve.  Your neck of the woods is on my bucket list to visit...someday.  In answer to your much earlier question about converting to a three wire line cord, yes, with this set you can connect the ground to chassis.  This is evident in your photo by the riveted ground clip on the back of the chassis to the right of the insulated antenna clip.  This is not always the case, but since it was intended to have a ground wire to earth you are really not changing anything.  The only possible disadvantage is that by grounding to the home wiring you could pick up "noise" from other equipment and appliances tied into the same ground network.  Take care, Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan


Messages In This Thread
Help with a Philco 89B - by kiwi_steve - 07-26-2015, 03:07 PM
RE: Help with a Philco 89B - by kiwi_steve - 07-26-2015, 03:34 PM
RE: Help with a Philco 89B - by Steve Davis - 07-26-2015, 05:11 PM
RE: Help with a Philco 89B - by morzh - 07-26-2015, 09:54 PM
RE: Help with a Philco 89B - by klondike98 - 07-26-2015, 10:02 PM
RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 07:44 AM
RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 07:59 AM
RE: Help with a Philco 89B - by morzh - 07-27-2015, 10:44 AM
RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 02:33 PM
RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 02:40 PM
RE: Help with a Philco 89B - by morzh - 07-27-2015, 03:14 PM
RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 05:42 PM
RE: Help with a Philco 89B - by kiwi_steve - 07-28-2015, 02:51 AM
RE: Help with a Philco 89B - by sam - 07-28-2015, 03:00 AM
RE: Help with a Philco 89B - by kiwi_steve - 07-28-2015, 05:18 AM
RE: Help with a Philco 89B - by morzh - 07-28-2015, 09:49 AM
RE: Help with a Philco 89B - by kiwi_steve - 07-29-2015, 08:06 AM
RE: Help with a Philco 89B - by GarySP - 07-29-2015, 08:35 AM
RE: Help with a Philco 89B - by kiwi_steve - 07-29-2015, 05:10 PM
RE: Help with a Philco 89B - by kiwi_steve - 08-01-2015, 07:48 PM
RE: Help with a Philco 89B - by kiwi_steve - 08-30-2015, 12:16 AM
RE: Help with a Philco 89B - by kiwi_steve - 08-30-2015, 01:11 AM
RE: Help with a Philco 89B - by kiwi_steve - 08-30-2015, 02:27 AM
RE: Help with a Philco 89B - by kiwi_steve - 08-30-2015, 08:54 PM
RE: Help with a Philco 89B - by kiwi_steve - 09-02-2015, 06:39 PM
RE: Help with a Philco 89B - by Arran - 09-03-2015, 01:03 AM
RE: Help with a Philco 89B - by kiwi_steve - 09-03-2015, 04:28 PM
RE: Help with a Philco 89B - by kiwi_steve - 09-22-2015, 05:18 PM
RE: Help with a Philco 89B - by kiwi_steve - 10-20-2015, 12:19 AM



Users browsing this thread: 7 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
OK, so 18 and 19 as they should be. What is "everything else?" Try to be more specific in your descriptions:...morzh — 12:44 PM
6TPZ and 5TPO Radio Help
Yeah, I'm still on 5TPO. Sorry, my bad, points 1 and 2 should be points 18 and 19 (easy mistake  :think: )  X7 is shown ...R3Sons — 11:42 AM
Philco 40-120C Filament Wiring
Hi folks, I'm in the process of restoring a Philco 40-120C and I'm finding the wiring to be a bit puzzling. According to...bluecap — 11:28 AM
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM

[-]
Who's Online
There are currently 6120 online users. [Complete List]
» 2 Member(s) | 6118 Guest(s)
AvatarAvatar

>