Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

6B4G substitute?
#1

Are there any substitutes for the 6B4G output tubes for my 37-116 De Luxe? I tested them and the one Philco is very weak and the Ken Rad measured @ 3900 where average/good is 3000. Would like to just replace them both but D**n they are pricey. Whats so special about them?


Messages In This Thread
6B4G substitute? - by sdradioman - 08-01-2015, 09:38 AM
RE: 6B4G substitute? - by morzh - 08-01-2015, 11:20 AM
RE: 6B4G substitute? - by sdradioman - 08-01-2015, 03:03 PM
RE: 6B4G substitute? - by Eliot Ness - 08-01-2015, 04:15 PM
RE: 6B4G substitute? - by Paul Philco322 - 08-01-2015, 05:44 PM
RE: 6B4G substitute? - by KCMike - 08-01-2015, 05:59 PM
RE: 6B4G substitute? - by Ron Ramirez - 08-01-2015, 08:28 PM
RE: 6B4G substitute? - by Phlogiston - 08-02-2015, 12:00 AM
RE: 6B4G substitute? - by Arran - 08-02-2015, 05:14 AM
RE: 6B4G substitute? - by morzh - 08-02-2015, 04:30 PM
RE: 6B4G substitute? - by codefox1 - 08-03-2015, 11:15 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM
B&K 1077B no video
I found a schematic and think I have the problem traced down to the minus power supply. I have very low voltages that go...TV MAN — 12:41 AM

[-]
Who's Online
There are currently 3509 online users. [Complete List]
» 1 Member(s) | 3508 Guest(s)
Avatar

>