Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Phono cartridge retro fit?
#16

That's good to know! I'll get there yet. I've grown some good sized Rochelle crystals and still intend to get the tilt cartridge working just to say I did but unless it works amazingly well (doubt it) I'm definitely following your example. Thanks!


Messages In This Thread
Phono cartridge retro fit? - by ODPILOT - 08-18-2015, 03:10 PM
RE: Phono cartridge retro fit? - by Squire - 08-18-2015, 05:51 PM
RE: Phono cartridge retro fit? - by ODPILOT - 08-18-2015, 09:11 PM
RE: Phono cartridge retro fit? - by Squire - 08-21-2015, 01:44 PM
RE: Phono cartridge retro fit? - by ODPILOT - 08-21-2015, 09:18 PM
RE: Phono cartridge retro fit? - by Squire - 08-21-2015, 11:08 PM
RE: Phono cartridge retro fit? - by ODPILOT - 08-22-2015, 07:30 AM
RE: Phono cartridge retro fit? - by Squire - 08-24-2015, 03:41 PM
RE: Phono cartridge retro fit? - by ODPILOT - 08-24-2015, 06:28 PM
RE: Phono cartridge retro fit? - by Squire - 08-24-2015, 07:16 PM
RE: Phono cartridge retro fit? - by ODPILOT - 09-06-2015, 08:13 AM
RE: Phono cartridge retro fit? - by Squire - 09-07-2015, 02:16 AM
RE: Phono cartridge retro fit? - by ODPILOT - 09-10-2015, 08:51 PM
RE: Phono cartridge retro fit? - by Squire - 09-11-2015, 08:08 PM
RE: Phono cartridge retro fit? - by ODPILOT - 09-19-2015, 12:00 PM
RE: Phono cartridge retro fit? - by Squire - 09-19-2015, 07:55 PM
RE: Phono cartridge retro fit? - by Squire - 10-02-2015, 02:20 AM
RE: Phono cartridge retro fit? - by sam - 10-02-2015, 03:38 AM
RE: Phono cartridge retro fit? - by Squire - 10-02-2015, 03:25 PM
RE: Phono cartridge retro fit? - by ODPILOT - 10-10-2015, 02:54 PM
RE: Phono cartridge retro fit? - by Squire - 10-11-2015, 11:47 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
462ron
Hi Levi, here’s just a thought. Most radios run the oscillator higher than the dial setting. Say you set your radio to 1...462ron — 10:10 AM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Another Update: I found a couple of damaged coils inside this radio that might have something to do with why this radio ...captainclock1988 — 10:51 PM
6TPZ and 5TPO Radio Help
If you are still on 5TPO, you lost me there. What X7? What Points 1 and 2?morzh — 08:37 PM
6TPZ and 5TPO Radio Help
Quick progress report: X7 is broken. Only one leg soldered, the other missing and the diode is cracked. I've replaced...R3Sons — 05:05 PM
6TPZ and 5TPO Radio Help
Oh...and you have electrolytic caps there. All need to go and be replaced.morzh — 04:36 PM
6TPZ and 5TPO Radio Help
Thanks, will do.R3Sons — 01:25 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
UPDATE: I was able to pick up a signal generator on the cheap (amazingly enough) on feebay and I did an IF alignment fol...captainclock1988 — 09:53 AM
Philco 91 Schematic
Hi Rod, The resistor connects to pin 4 and the ungrounded side of block 9. From pin 9 of the RF tube to one side of ...dconant — 09:34 AM
Just got a 49-1613 need to know...everything!
I just found your post. I have this exact same model, and have had it since 1985 when I was 15 years old! I performed a ...MuzzcoVW — 09:11 AM
B&K 1077B no video
Hello Tim, I would if it's a leaky Capacitor So are all 3 of those B- voltages low then ? Sincerely Richardradiorich — 01:55 AM

[-]
Who's Online
There are currently 5348 online users. [Complete List]
» 1 Member(s) | 5347 Guest(s)
Avatar

>