[bastardbus]

Thanks Terry for some of that info.

I re wound my osc tonight and it is drying right now.  Hope to try it later tonight.

I did figure out the cap-resistor situation.  It was NOT in parallel with the coil but in series like the schematic.  The only thing is on mine the cap and resistor are in series BEFORE the coil now instead of after it.  The two parts in earlier runs had the two after the coil and this newer run they mounted those two on the coil itself.  The first coil pin it is on is blank (what confused me) and the 36 attaches there.  The opposite end of the cap-resistor ends on the beginning of the osc coil.  That then comes out at the ground pin.  This was very difficult to see until I actually took removed all the bas osc coil and insulator and could see where the wires-pins were all attached to.

I tell you what....I sure don't like winding coils.  Had enough of that for a while.

T