Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-116 Mag Tuning question
#1

I've had one for close to 30yrs now that I got at an auction for $35. When I got it I replaced all the caps and such and it work great. About 10yrs ago it died and I'm thinking about putting her up on the bench and seeing what the matter is. I have a simple question. Does the mag tuning operate on the BC band only or will it act as an afc circuit on SW?
Tnx
Terry
Going the pickup a 37-675 tomorrow!! Tnx to Pete in NJ

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#2

Hi Terry,

I restored a 37-675 (non tele-dial version) a few years ago. I believe that the 675 and 116 use the same sub-chassis. I thought that the magnetic tuning was used on all bands on the 675 and the schematic for the 116 confirms that. I was very pleased with the performance of the 675. If I had not bought a 16X I would have kept the 675. That sub chassis was a major pain to work on.

Sean
WØKPX
#3

7estatdef Wrote:I've had one for close to 30yrs now that I got at an auction for $35. When I got it I replaced all the caps and such and it work great. About 10yrs ago it died and I'm thinking about putting her up on the bench and seeing what the matter is. I have a simple question. Does the mag tuning operate on the BC band only or will it act as an afc circuit on SW?
Tnx
Terry
Going the pickup a 37-675 tomorrow!! Tnx to Pete in NJ

Works on all bands. See the Magnetic Tuning info from my site:

PHILCO SERVICE HINTS & TIPS - NUMBER 33
Aligning the Magnetic Tuning System
http://www.philcorepairbench.com/tips/svctip33.htm

Chuck




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM
Var resistor id
Considering what it is in series with, I doubt there should be any power requirements. Of course, we should know wher...morzh — 03:23 PM
Var resistor id
Trim pot, about 1/2 watt part of focus divider. As stated 2k ohms. This appears to be a rusty chassis, resolder all ...Chas — 03:19 PM
Var resistor id
Its a Sylvania 400 oscilloscope. here is a clip of r-100. Would be nice to know the current required. Not listed in part...Martinj — 02:10 PM
The list of my radio & TV collection!
Thanks Richard. I hope you enjoy it. Here I have created an English section on the history of radio with videos in Engl...RadioSvit — 10:23 AM
The list of my radio & TV collection!
Hello RadioSvit, first all happy new year ! I will watch your new videos this week. Sincerely Richardradiorich — 09:19 AM

[-]
Who's Online
There are currently 8884 online users. [Complete List]
» 1 Member(s) | 8883 Guest(s)
Avatar

>