Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-38 Mystery Part
#1

I'm considering picking up two consoles this weekend. My interest is mainly in a 610.  Due to a proviso that 'both must go,' I'm towing a 38-38 along with me. It will be my introduction to the farm radio experience which I am mildly excited about. I asked the seller if the radio had been upgraded for AC use only because he said it last played about ten years ago (haven't they all?) Anyway, he said it had a cord and plug and I noticed a contraption in the bottom of the cabinet which I did not recognize (see attached.) Can anyone please educate me on the purpose of this mystery part? Thanks in advance.


Attached Files Image(s)
   
#2

Looks like a power pack to allow operation on mains power. http://www.nostalgiaair.org/Resources/248/M0013248.htm     Looks like a fun project, or it could be the flux capacitor out of a time machine! Some more info https://philcoradio.com/phorum/showthread.php?tid=21485
#3

Thanks for the info David. That sounds promising about the former. Hedging my bets, does Riders contain a schematic for the latter? I may need it to go back and pick up the former.
#4

Might be one of these: http://www.nostalgiaair.org/pagesbymodel...017907.pdf

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

Great. Thanks Terry! I will definitely pore over that literature. I'm very green on radio repair in general so this will be a big help in trying to understand how these adaptors work.
#6

Some more info on a battery eliminator   https://philcoradio.com/phorum/showthread.php?tid=21451
#7

Thanks David and Terry for pointing me in the right direction on this. You guys were right on, as expected. I saw the Sears silvertone and Electro (pictured below) models of the battery eliminator and they look almost identical to the image I have. Thanks again, I really appreciate your help.


Attached Files Image(s)
       




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
6TPZ and 5TPO Radio Help
Welcome to the Phorum, R3Sons! I have very limited experience with car radios other than installing custom radios back ...GarySP — 01:08 PM
462ron
OK, I need to rename this thread to say..Eico 368 TV/FM Sweep Generator instead of the current title..Heathkit Sweep Gen...462ron — 12:49 PM
6TPZ and 5TPO Radio Help
Hello, I have a Philco (Ford) 6TPZ and a 5TPO radio.  I replaced the electrolytic capacitors in both.  I have the SAMS m...R3Sons — 12:29 PM
The list of my radio & TV collection!
Hello Peter, Thank you for posting that !! Sincerely Richardradiorich — 09:40 AM
Eico 232 VTVM Schematic
It's a microwave antenna. ?;-p?. I substituted 1N4002s off the 6.3 vac winding for the 1.5 volt battery. Uniprobe is the...RodB — 05:50 PM
Eico 232 VTVM Schematic
Try BAMA for a schematic. Looks like a replacement power source for the D battery has been installed. The tube may be...Chas — 04:51 PM
Eico 232 VTVM Schematic
Is that a battery holder?morzh — 04:43 PM
Eico 232 VTVM Schematic
A friend gave me this Eico 232 VTVM and I'm having trouble locating the schematic for it. This one seems to be a later v...RodB — 04:17 PM
Var resistor id
Considering what it is in series with, I doubt there should be any power requirements. Of course, we should know wher...morzh — 03:23 PM
Var resistor id
Trim pot, about 1/2 watt part of focus divider. As stated 2k ohms. This appears to be a rusty chassis, resolder all ...Chas — 03:19 PM

[-]
Who's Online
There are currently 3293 online users. [Complete List]
» 1 Member(s) | 3292 Guest(s)
Avatar

>