Posts: 70
Threads: 17
Joined: Jan 2006
City: Newbern
State, Province, Country: Tennessee
Have a RP3. Recapped, replaced resistors, and installed a new crystal cartridge. Still will only broadcast about 2ft. no more. Checked tubes, strong. am I missing something?
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
I would suspect that many people have no idea what an RP3 is (I once worked on a Sonora RP3). Maybe if you told us a little more about it - picture?
https://www.radiomuseum.org/r/philco_rp3.html
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Posts: 70
Threads: 17
Joined: Jan 2006
City: Newbern
State, Province, Country: Tennessee
It's a Philco wireless 1939 record player.
Posts: 1,238
Threads: 30
Joined: Jan 2014
City: Wellborn Florida
What kind of ant. are you using?
Posts: 70
Threads: 17
Joined: Jan 2006
City: Newbern
State, Province, Country: Tennessee
one used in the original factory design.
Posts: 7,294
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
Posts: 70
Threads: 17
Joined: Jan 2006
City: Newbern
State, Province, Country: Tennessee
Posts: 7,294
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
So how much ac voltage do you have from pin 2 of the 84 to chassis and pin 3 to the chassis?
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
So you have a 6A7 doing its thing ( it is normally a osc/mixer in a receiver).
What is your plate voltage? Have you looked at it with a scope, how about a signal sniffer. I would suspect that a really good 6A7 might be required to get good range, not my favorite tube - still trying to get the Strat to osc. on band 5, reliably.
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
(This post was last modified: 12-09-2020, 06:26 PM by Phlogiston.)
Posts: 70
Threads: 17
Joined: Jan 2006
City: Newbern
State, Province, Country: Tennessee
105.1 v pin 2 and 105.4 pin 3
Posts: 70
Threads: 17
Joined: Jan 2006
City: Newbern
State, Province, Country: Tennessee
plate on the 6A7 is 101.5v
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
Is that 1 meg variable resistor good? What happens when you adjust it?
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Posts: 70
Threads: 17
Joined: Jan 2006
City: Newbern
State, Province, Country: Tennessee
yes. it shuts down the transmitting when turned be it on a little over 2 ft.
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
I would think that it would vary the RF output considerably through the range, 0 to 1meg. So if you measure from the high side (xtal) to ground you get 1 meg.? I have to ask - again, because these Philco controls are often the problem, especially if they have been "cleaned".
It may also vary the output freq. a little. What is you output freq?
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Posts: 16,317
Threads: 569
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
6A7 tubes are often weak. The Mixing part.
Maybe it just needs replacement.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
Users browsing this thread: 6 Guest(s)
|
|
Recent Posts
|
|
Philco 49-1040
|
| Hello Bob,
You are like the home for lost tv's like how people bring pets home !
Sincerely Richardradiorich — 12:00 AM |
|
Philco 49-1040
|
| I thought I had an arrangement to restore this set for a customer but his wife said heck no. Instead, he gave it to me....Bob Andersen — 10:29 PM |
|
Philco 46-480 Electronic Restoration
|
| I kept working on reassembly this week. I wasn’t able to solder for a few days while it was too cold (single digit low t...jrblasde — 09:27 PM |
|
Atwater-Kent 84, restoration.
|
| Well, powering it up would be too good to be true, and I had that feeling.
Before I did, I decided to check the coils...morzh — 06:02 PM |
|
An attempt to remove the Field Coil from a G speaker
|
| Thanks Chas,
sure will give it a look!morzh — 03:39 PM |
|
An attempt to remove the Field Coil from a G speaker
|
| Mike,
Lookup murrayatuptown on ARF. Seems he has a dilemma with surplus field coils. Could get lucky and have what y...Chas — 01:26 PM |
|
Atwater-Kent 84, restoration.
|
| Hello Mike,
I have not checked to see if my console has a fuse or not and far as sets go I have early 30s General Motor...radiorich — 11:25 AM |
|
Atwater-Kent 84, restoration.
|
| Ron
I forgot, but when you said "phone number", I remembered, caus I usually remember how I act when I need...morzh — 11:12 AM |
|
Atwater-Kent 84, restoration.
|
| You have an extensive collection of Philcos, Mike! I’m always excited to see each new one. Agreed on the power supply fu...jrblasde — 10:50 AM |
|
462ron
|
| Hi Mike, that 84 sure looks great. You don’t often see these antique radios with a fuse like yours has. I usually instal...462ron — 10:22 AM |
|
Who's Online
|
| There are currently no members online. |
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
