Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-295 Developed Intermittent Crackling
#1

I electronically restored a 41-295. It has recently developed a crackling sound. It sometimes levels off when it's tuned to a station, but will excite back up when going down the dial. I have replaced almost all the caps except three mica caps, and I've replaced all the resistors. I've probed around looking for sold solder joints or anything loose, but have not found anything conclusive. Besides the crackling it's a fantastic set. Receives well and sounds wonderful. Any tips from the Philco experts out there on this cracking?
#2

(03-06-2012, 04:37 PM)Sourbone Wrote:  I electronically restored a 41-295. It has recently developed a crackling sound. It sometimes levels off when it's tuned to a station, but will excite back up when going down the dial. I have replaced almost all the caps except three mica caps, and I've replaced all the resistors. I've probed around looking for sold solder joints or anything loose, but have not found anything conclusive. Besides the crackling it's a fantastic set. Receives well and sounds wonderful. Any tips from the Philco experts out there on this cracking?

Could be a bad mica but I'd grab the tracer poke around till I found the problem.
Terry
#3

Only 3 mica caps to go? Replace 'em. But only after the gentle tapping and probing with a dry old chopstick reject from the kitchen. I assume that tube pins, sockets and switches have received their once every 50 years Deoxit shower.

Else you may be poking around until next Christmas.




Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently no members online.

>