Posts: 99
Threads: 18
Joined: Nov 2011
(This post was last modified: 04-27-2013, 03:55 PM by
fixinmyphilco.)
Posts: 262
Threads: 27
Joined: Jan 2010
City: Rochester, NY
Didnt use any stripper?
Did you sand by hand?
Going to use spray toner? Stain?
Looks good.
Tim
Posts: 99
Threads: 18
Joined: Nov 2011
Used a electric hand sander 80 grit paper went over it following the different grains in the wood,being careful to just take the lacquer off to bare wood will go over it with fine paper next apply some light stain to the bottom and the strip just at the top. Then spray Lacquer it all over..Did it the same way to the radio(except for a slightly lighter stain will go on mine) I gave to my Sister..here's a pic of hers
[Image: http://i1095.photobucket.com/albums/i474...IM1613.jpg]
(This post was last modified: 04-29-2013, 08:48 PM by
fixinmyphilco.)
Posts: 4,804
Threads: 54
Joined: Sep 2008
City: Sandwick, BC, CA
I would highly recommend that you use a chemical stripper next time rather then a sander, there isn't much meat to the veneer all it takes is one slip up and you've burned right through it.
I have a Philco 620 where someone used a an electric disk sander on it, not only are there a bunch of swirl marks but they all but ruined the molding on the front panel. Unfortunately the only way to repair the swirl marks is to reveneer the front panel, they are too deep to sand out, the moldings I'm not sure what to do with.[/u]
Regards
Arran
Posts: 99
Threads: 18
Joined: Nov 2011
Posts: 16,213
Threads: 562
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
I can even see you in this photo
Posts: 99
Threads: 18
Joined: Nov 2011
Posts: 16,213
Threads: 562
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
CDs go well together with it
Posts: 99
Threads: 18
Joined: Nov 2011
Posts: 99
Threads: 18
Joined: Nov 2011
Im so glad I took the time to post the pictures I think it will be a Long time before I make that mistake here again.
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
Which mistake was that?
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Posts: 403
Threads: 40
Joined: Feb 2011
City: McPherson, KS
I like it.
Posts: 262
Threads: 27
Joined: Jan 2010
City: Rochester, NY
Looking good!
Nice job!
Tim
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
