Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith Transoceanic battery-opinion
#1

Hi Guys,
I am finishing up my A600 Transoceanic and once it is finished it will be for sale. My question is whether I should go through the trouble to build a battery pack(these batteries are no longer available) or just sell it to run on A/C. The battery pack will cost me about $45.00 to construct plus the cost of 10 9 volt and 4 D cell batteries.
What do you think? Since it will not be an original battery, will it still be important to a buyer/collector?

Thanks,

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org

#2

eric
I don`t think it would be worth it to make battery
would increase 50. to 75. more for radio
as most don`t play them often or ones that do have batteries play very little from what I seen
sam

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
#3

 If your intent is just to fix this T.O up for resale I think that making a battery pack for it is a waste of time. I don't think it would add much, if any value, to a 600 series T.O, those seem to be among the most common tube T.O models you can find. Since these were all so called "three way" portables most people would just operate them from a line cord, if they wanted one that would be practical to run from batteries they can always pick up a later transistor model T.O. 
Regards
Arran
#4

Unless you want to sell the battery you make for a profit.
But: You cannot be sure that whosoever buys it will want the battery.
And: this whosoever can buy a battery from people who build and sell them should he ever want it.
#5

Icon_thumbup Thanks guys. I tend to agree with all of you.

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org





Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Gary I in fact did, on a 38-14, I think, where I had a speaker with the dead coil. Well...it kinda worked. Kinda, be...morzh — 10:38 PM
An attempt to remove the Field Coil from a G speaker
Mike, what ever happened to that plan you had to try using a rare earth magnet to magnetize the pole? This looks like a...GarySP — 10:25 PM
RCA T62 is playing.....
Beautiful set.morzh — 09:07 PM
An attempt to remove the Field Coil from a G speaker
Well....here it is. The green stuff. Unfortunately, probably penetrates deep. I opened the top layer and saw that: ...morzh — 08:58 PM
Philco 91 Restore Code ??
:clap: :clap: :clap: :clap: Really nice workmanship!!! Top of the chassis looks great. Sorry about the long winded e...MrFixr55 — 08:09 PM
Philco 40-120C Restoration
Thank you for your reply. I will check voltages on the other tubes, look at resistor 23 and cap 25, etc. If all else fai...bluecap — 07:58 PM
RCA T62 is playing.....
Nice looking set great save. DavidDavid — 07:48 PM
Philco 89 indicator light.
Hello Jim, I have done several 89s. The trick is to move the drum in or out on it's shaft. You will need to loosen a set...dconant — 07:36 PM
An attempt to remove the Field Coil from a G speaker
MrFixr Yes, it is my plan to go with 45rpm spider if I go that far. No, the pole was not left-handed as I unscrewed ...morzh — 07:14 PM
Philco 40-120C Restoration
Change the tube. Check the tube's bias network. Are any other tubes experience the drop or just this?` Is resistor 23 OK...morzh — 07:09 PM

[-]
Who's Online
There are currently 7205 online users. [Complete List]
» 1 Member(s) | 7204 Guest(s)
Avatar

>